Hello, welcome to the official website of KGW Purification Project!
The national service telephone is:4000-2288-21KGW Purification Engineering——Factory purification engineering, purification equipment solution provider
Integrate R&D, design, production, installation, and engineering solutionsShenzhen official website of KGW Purification Project
Tel400:4000-2288-21
Tel:0755-27273691
Fax:0755-27273695
Business line:0755-27258600
Site:Blue Sky science park,Donghuan Road,Shajing,Baoan,Shenzhen,China.
Cargo Air shower
Brief introduction
The cargo Air shower is a necessary channel for goods to enter the clean room. It can reduce the pollution problem caused by goods entering and leaving the clean room.
Cargo Air shower electronic interlock two doors,which also play the role of the gas chamber, prevent not by purification of air into the clean room, high-tech intelligent voice cargo Air shower room with voice prompt system, prompted by the automatic speech system when blowing rain, human voice prompt give a person a kind of warm feeling,and achieve effective purification effect, with high efficiency filter filtered and clean air by rotating the nozzle from injection to people in all directions, effective and rapid removal of dust particles.
Product Description
1. Two-speed fan
2. Primary filter
3. Stainless steel nozzle (with protective net)
4. No partition high efficiency filter
5. Toughened glass window
6. Emergency stop switch (3 in total)
7. Indicator light
8. Light Infrared sensors
9. Control panel (with glass cover)
10. Anchor bolts (M12)
11. Entrance door closing device
Optional accessories
1. All stainless steel body
2. Stainless steel inner wall
3. Ultraviolet sterilizing lamp
4. Electrostatic removal device
Maintenance points
1. Regularly use the instrument to measure various technical indicators of the equipment, and if it does not meet the requirements of technical parameters, it shall be timely handled.
2. Remove the filter material from the primary effect air filter regularly according to the actual use situation.
3, when wind speed change hours should be at the beginning of the first check air filter surface is black, if black shows the pre-filter let dust is more, resistance increases, which should be removed in the early of the non-woven fabric air filter and clean or change.
4. When the non-woven fabric is replaced or cleaned, but the wind speed still cannot be increased, it indicates that the high-efficiency air filter has been blocked, causing increased resistance, then the high-efficiency air filter should be replaced.
5. When replacing the high-efficiency filter, the ball spraying plate shall be removed, the high-efficiency filter shall be taken out, and the new high-efficiency air filter shall be replaced according to the specifications and models of the original high-efficiency filter.
The arrow mark on the high efficiency filter should be confirmed when installing. The arrow should point in the direction of airflow.
And make sure the seal is good to prevent leakage.
6. After the replacement of the high-efficiency filter, the border shall be confirmed free of leakage and the dust particle counter shall be used for detection. The technical indicators shall be met before the normal operation can be carried out.
7. Conduct regular maintenance of electrical lines. If there is any fault, please refer to the electrical schematic diagram for maintenance.
8.Maintain the door regularly so that the electronic lock is aligned with its lock hole, so as to avoid the lock pin sticking.
9. This equipment use temperature shall not exceed 50 ℃, and open flame is strictly prohibited.